Paneling Tool Guide

To replace wood veneer panels, you’ll need the following:

-	Goggles
-	A broad pry bar
-	Small triangular wood wedges and an approx. two-inch deep wood block
-	A hammer w/ nail puller
-	Chisel
-	Carpenter’s adhesive in a squeeze tube or caulking gun
-	Crosscut saw (if you need to cut the panel to fit)

To replace tongue and groove wood panels, you’ll need:

-	A circular saw (to remove old panel)
-	Crosscut saw (to cut new panel to size)
-	Goggles and earplugs
-	Small triangular wood wedges
-	A hammer
-	Finishing nails
-	A broad pry bar
-	A wood chisel
-	A vise grip and two 4 x 4" wood blocks
-	A nail sink (to sink nail heads below the panel surface)